Toro Titan 5400C, Руководство оператора

Страница: 43 / 52

Leveling the Mower Deck
Check to ensure that the mower deck is level any time
you install the mower or when you see an uneven cut
on your lawn.
Check the mower deck for bent blades prior to
leveling, and remove and replace any bent blades;
refer to
Checking for Bent Blades (page 40) before
continuing.
Level the mower deck side-to-side first; then you can
adjust the front-to-rear slope.
Requirements:
•
The machine must be on a level surface.
•
All tires must be properly inflated; refer to Checking
the Tire Pressure (page 38) .
Checking the Side-to-Side Level
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Set the height of cut to 76 mm (3 inches).
4. Carefully rotate the blades side to side.
5. Measure between the outside cutting edges and
the flat surface (
Figure 56 ).
Note:
If both measurements are not within 5
mm (3/16 inch), an adjustment is required; refer
to
Leveling the Mower Deck (page 43) .
g229303
Figure 56
1. Blades side to side
3. Measure from the tip of the
blade to the flat surface
here.
2. Outside cutting edges
Checking the Front-to-Rear Blade
Slope
Check the front-to-rear blade level any time you install
the mower. If the front of the mower is more than
7.9 mm (5/16 inch) lower than the rear of the mower,
adjust the blade level.
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Set the height of cut to 76 mm (3 inches).
4. Carefully rotate the blades so they are facing
front to rear (
Figure 57 ).
5. Measure from the tip of the front blade to the
flat surface and the tip of the rear blade to the
flat surface (
Figure 57 ).
Note:
If the front blade tip is not 1.6 to 7.9 mm
(1/16 to 5/16 inch) lower than the rear blade tip,
continue to the
Leveling the Mower Deck (page
44) procedure.
g229304
Figure 57
1. Blades front to rear 3. Measure from the tip of the
blade to the flat surface
here.
2. Outside cutting edges
43