Toro TimeMaster 20976, Руководство оператора

Страница: 17 / 128

Side-Discharging the
Clippings
Use the side discharge for cutting very tall grass.
If the bag is on the machine, remove it and insert the
rear-discharge plug; refer to
Removing the Grass Bag
(page 15) before side-discharging the clippings.
Important:
Ensure that the rear-discharge plug is
in place before you recycle the clippings ( Figure
25 ).
Installing the Side-Discharge
Chute
1. Lift open the side-discharge door ( Figure 28 ).
g017521
Figure 28
1. Side-discharge door 2. Side-discharge chute
2. Install the side-discharge chute as shown in
Figure 28 and Figure 29 , and close the door
onto the chute.
g017522
Figure 29
Removing the Side-Discharge
Chute
To remove the side-discharge chute, reverse the steps
in
Installing the Side-Discharge Chute (page 16) .
Operating Tips
General Mowing Tips
•
Inspect the area where you will use the machine
and remove all objects that the machine could
throw.
•
Avoid striking solid objects with the blades. Never
deliberately mow over any object.
•
If the machine strikes an object or starts to vibrate,
immediately shut off the engine, remove the key
(if equipped), disconnect the wire from the spark
plug, and examine the machine for damage.
•
For best performance, install new blades before
the cutting season begins.
•
Replace the blades when necessary with Toro
replacement blades.
Cutting Grass
•
Cut only about a third of the grass blade at a time.
Do not cut below 51 mm (2 inches) unless the
grass is sparse or it is late fall when grass growth
begins to slow down.
•
When cutting grass over 15 cm (6 inches) tall,
mow at the highest cutting height setting and walk
slower; then mow again at a lower setting for the
best lawn appearance. If the grass is too long, the
machine may plug and cause the engine to stall.
•
Wet grass and leaves tend to clump on the yard
and can cause the machine to plug or the engine
to stall. Avoid mowing in wet conditions.
16