10.
When the front-to-rear blade slope is correct check the
side-to-side level of the mower again, refer to
from Side to Side (page 45)
.
Removing the Mower
1.
Park the machine on a level surface and disengage the
blade-control switch.
2.
Move the motion-control levers outward to the park
position, stop the engine, remove the key, and wait for
all moving parts to stop before leaving the operating
position.
3.
Lower the height-of-cut lever to the lowest position.
4.
Loosen the bottom two bolts holding the mower-deck
curtain to the mower deck. Refer to
Mower-Deck Curtain (page 33)
.
5.
Remove the hairpin-cotter pin from the front support
rod, and remove the rod from the deck bracket (
G014635
1
2
3
Figure 66
1.
Front support rod
3.
Deck bracket
2.
Locking nut
6.
Carefully lower the front of the mower deck to the
ground.
7.
Lift the mower deck and hanger brackets clear of
the rear lift rod and lower the mower carefully to the
ground (
).
2
2
3
G005077
1
2
2
3
Figure 67
1.
Mower deck
3.
Rear lift rod
2.
Hanger bracket
8.
Slide the mower deck rearward to remove the mower
belt from the engine pulley.
9.
Slide the mower deck out from underneath the
machine.
Note:
Retain all parts for future installation.
Installing the Mower
1.
Park the machine on a level surface and disengage the
blade-control switch.
2.
Move the motion-control levers outward to the park
position, stop the engine, remove the key, and wait for
all moving parts to stop before leaving the operating
position.
3.
Slide the mower under the machine.
4.
Lower the height-of-cut lever to the lowest position.
5.
Lift the rear of the mower deck and guide the hanger
brackets over the rear lift rod (
).
6.
Attach the front support rod to the mower deck with
the clevis pin and hairpin-cotter pin (
7.
Install the mower belt onto the engine pulley; refer to
Replacing the Mower Belt (page 49)
.
8.
Tighten the bottom two bolts holding the mower-deck
curtain to the mower deck. Refer to
Mower-Deck Curtain (page 33)
.
47
Содержание timecutter zs 4200t
