Toro TimeCutter ZS 3200S, Руководство оператора

Страница: 28 / 56

Premaintenance
Procedures
Raising the Seat
Make sure that the motion-control levers are locked in the
park position, and lift the seat forward.
The following components can be accessed by raising the seat:
•
Serial plate
•
Service decal
•
Seat-adjustment bolts
•
Fuel filter
•
Battery and battery cables
Releasing the Mower-Deck
Curtain
Loosen the 2 bottom bolts of the curtain to gain access to the
top of the mower deck (
Figure 29 ).
Figure 29
1. Bottom bolt 2. Curtain
Lubrication
Greasing the Bearings
Service Interval: Every 25 hours—Grease all the lubrication
points.
Grease Type: No. 2 general purpose, lithium-based Grease
1. Park the machine on a level surface, and disengage the
blade-control switch.
2. Move the motion-control levers outward to the park
position, stop the engine, remove the key, and wait for
all moving parts to stop before leaving the operating
position.
3. Clean the grease fittings ( Figure 30 and Figure 31 ) with
a rag.
Note:
Make sure to scrape any paint off of the front
of the fitting(s).
1
G014522
Figure 30
1. Front caster tire
Figure 31
Located on the seat-pan underside
1. Read the instructions
before servicing or
performing maintenance 3. Grease every 25 operating
hours
2. Check the tire pressure
every 25 operating hours
4. Engine
4. Connect a grease gun to each fitting ( Figure 30 and
Figure 31 ).
28