Cleaning
Cleaning under the Front of
the Machine
Service Interval:
After each use—Check and clean the front
of the mower.
Remove debris under the front of the machine with
compressed air or by hand with a brush (
).
Note:
Do not use water to clean under the front of the
machine, this can cause build up of debris.
Figure 65
Washing the Underside of the
Mower Deck
Service Interval:
After each use—Clean the mower housing.
Important:
You can wash the machine with mild
detergent and water. Do not pressure wash the machine.
Avoid excessive use of water, especially near the control
panel, under the seat, around the engine, hydraulic
pumps, and motors.
Wash the underside of the mower after each use to prevent
grass buildup for improved mulch action and clipping
dispersal.
1.
Park the machine on a level surface and disengage the
blade-control switch.
2.
Engage the parking brake, shut off the engine, remove
the key, and wait for all moving parts to stop before
leaving the operating position.
3.
Attach the hose coupling to the end of the mower
washout fitting, and turn the water on high (
Note:
Spread petroleum jelly on the washout fitting
O-ring to make the coupling slide on easier and protect
the O-ring.
G020098
2
4
1
2
3
4
Figure 66
1.
Washout fitting
3.
O-ring
2.
Hose
4.
Coupling
4.
Lower the mower to the lowest height of cut.
5.
Sit on the seat and start the engine. Engage the
blade-control switch and let the mower run for 1 to 3
minutes.
6.
Disengage the blade-control switch, shut off the
engine, and remove the ignition key. Wait for all
moving parts to stop.
7.
Turn the water off and remove the coupling from the
washout fitting.
Note:
If the mower is not clean after 1 washing, soak it
and let it stand for 30 minutes. Then repeat the process.
8.
Run the machine and mower blades again for 1 to 3
minutes to remove excess water.
9.
Turn off the mower blades.
WARNING
A broken or missing washout fitting could
expose you and others to thrown objects or
blade contact. Contact with a blade or thrown
debris can cause injury or death.
•
Replace broken or missing washout fitting
immediately, before using mower again.
•
Never put your hands or feet under the
mower or through openings in the mower.
47
Содержание TimeCutter SW5425
Страница 51: ...Schematics Electrical Diagram Rev A 51 ...
