Toro TimeCutter SW 5000, Руководство оператора

Страница: 44 / 56

g009658
Figure 53
Mower Decks with 2 Blades
1. Blades front to rear
2. Measure from the tip of the blade to the flat surface here
g009659
Figure 54
Mower Decks with 3 Blades
1. Blades front to rear 3. Measure from the tip of the
blade to the flat surface
here
2. Outside cutting edges
5. Measure from the tip of the front blade to the flat
surface, and the tip of the rear blade to the flat
surface (
Figure 53 and Figure 54 ).
Note:
If the front blade tip is not 1.6 to 7.9 mm
(1/16 to 5/16 inch) lower than the rear blade tip,
adjust the front locknut.
6. To adjust the front-to-rear blade slope, rotate the
adjustment nut in the front of the mower (
Figure
55 ).
g014634
Figure 55
1. Adjusting rod 3. Locknut
2. Adjusting block
7. To raise the front of the mower, tighten the
adjustment nut.
8. To lower the front of the mower, loosen the
adjustment nut.
9. After adjustment, check the front-to-rear slope
again, continue adjusting the nut until the front
blade tip is 1.6 to 7.9 mm (1/16 to 5/16 inch)
lower than the rear blade tip (
Figure 53 and
Figure 54 ).
10. When the front-to-rear blade slope is correct
check the side-to-side level of the mower again,
refer to
Side-to-Side Leveling (page 42) .
Removing the Mower
1. Park the machine on a level surface and
disengage the blade-control switch.
2. Ensure that the parking brake is engaged,
shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Lower the height-of-cut lever to the lowest
position.
4. Remove the hairpin cotter from the front support
rod and remove the rod from the deck bracket
(
Figure 56 ). Carefully lower the front of the
mower deck to the ground.
44