G015323
1
2
3
4
5
Figure 52
1.
Hanger bracket
3.
Side locking nut
2.
Rear locking nut
4.
Adjustment notches
10.
Use the notches on the welded bracket to measure
the amount of adjustment. Each notch surface is
equivalent to 0.25 inch , while a single side is 0.125
inch (Figure 53). Adjust the height of the mower deck
to the desired height.
G015325
1
2
Figure 53
1.
0.25 inch
2.
0.125 inch
11.
Stop the deck at the adjusted position and tighten the
rear locking nut on the hanger bracket to hold the new
position (Figure 52). Tighten the side locking nut on
the hanger bracket.
12.
Continue leveling the deck by checking the front-to-rear
blade slope; refer to Adjusting the Front-to-Rear Blade
Slope.
Adjusting the Front-to-Rear Blade
Slope
Check the front-to-rear blade level any time you install the
mower. If the front of the mower is more than 5/16 inch
(7.9 mm) lower than the rear of the mower, adjust the blade
level using the following instructions:
1.
Park the machine on a level surface and disengage the
blade control switch.
2.
Move the motion control levers outward to the park
position, stop the engine, remove the key, and wait for
all moving parts to stop before leaving the operating
position.
3.
Set the height-of-cut lever to middle position.
Note:
Check and adjust the side-to-side blade level if
you have not checked the setting; refer to Side-to-Side
Leveling.
4.
Carefully rotate the blades so they are facing front to
rear (Figure 54 ).
G009658
1
2
2
Figure 54
1.
Blades front to rear
2.
Measure from the tip of the blade to the flat surface here
5.
Measure from the tip of the front blade to the flat
surface and the tip of the rear blade to the flat surface
(Figure 54 ). If the front blade tip is not 1/16-5/16 inch
(1.6-7.9 mm) lower than the rear blade tip, adjust the
front locknut.
6.
To adjust the front-to-rear blade slope, rotate the
adjustment nut in the front of the mower (Figure 55).
G014634
1
2
3
Figure 55
1.
Adjusting rod
3.
Lock nut
2.
Adjusting block
36
Содержание TimeCutter SS 4216
Страница 43: ...Schematics G014644 Electrical Diagram Rev A 43 ...
Страница 44: ...Notes 44 ...
Страница 45: ...Notes 45 ...
