Toro TimeCutter HD ZX4800, Руководство оператора

Страница: 27 / 56

on the down side of the slope and the ramp extends
up the slope. This will minimize the ramp angle.
WARNING
Loading a machine onto a trailer or truck
increases the possibility of tip-over and could
cause serious injury or death.
• Use extreme caution when operating a
machine on a ramp.
• Use only a full-width ramp; do not use
individual ramps for each side of the
machine.
• Do not exceed a 15-degree angle between
the ramp and the ground or between the
ramp and the trailer or truck.
• Ensure the length of ramp is at least four
times (4X) as long as the height of the
trailer or truck bed to the ground. This will
ensure that ramp angle does not exceed 15
degrees on flat ground.
• Back up ramps and drive forward down
ramps.
• Avoid sudden acceleration or deceleration
while driving the machine on a ramp as
this could cause a loss of control or a
tip-over situation.
g027996
Figure 30
1. Full-width ramp in stowed
position 4. Ramp is at least four times
(4X) as long as the height
of the trailer or truck bed
to the ground
2. Side view of full-width
ramp in loading position 5. H= height of the trailer or
truck bed to the ground
3. Not greater than
15 degrees 6. Trailer
Towing the Machine
•
Do not attach towed equipment except at the hitch
point.
•
Follow the attachment manufacturer's
recommendation for weight limits for towed
equipment and towing on slopes. Towed
weight must not exceed the weight of the
machine, operator, and ballast; otherwise
hydrostatic transmission failure may occur. Use
counterweights or wheel weights as described in
the attachment manufacturer's manual.
•
Never allow children or others in or on towed
equipment.
•
On slopes, the weight of the towed equipment may
cause loss of traction, increased risk of rollover,
27