Toro TimeCutter HD X4850, Руководство оператора

Страница: 29 / 56

g027996
Figure 37
1. Full-width ramp in stowed
position 4. Ramp is at least 4 times
as long as the height of
the trailer or truck bed to
the ground
2. Side view of full-width
ramp in loading position 5. H=height of the trailer or
truck bed to the ground
3. Not greater than
15 degrees 6. Trailer
Loading the Machine
WARNING
Loading a machine onto a trailer or truck
increases the possibility of tip-over and could
cause serious injury or death.
• Use extreme caution when operating a
machine on a ramp.
• Back the machine up the ramp and drive it
forward down the ramp.
• Avoid sudden acceleration or deceleration
while driving the machine on a ramp as
this could cause a loss of control or a
tip-over situation.
1. If using a trailer, connect it to the towing vehicle
and connect the safety chains.
2. If applicable, connect the trailer brakes and
lights.
3. Lower the ramp, ensuring that the angle
between the ramp and the ground does not
exceed 15 degrees (
Figure 37 ).
4. Back the machine up the ramp ( Figure 38 ).
g027995
Figure 38
1. Back the machine up the
ramp. 2. Drive the machine forward
down the ramp.
5. Shut off the engine, remove the key, and engage
the parking brake.
6. Tie down the machine near the front caster
wheels and the rear bumper with straps, chains,
cable, or ropes (
Figure 39 ). Refer to local
regulations for tie-down requirements.
g027708
Figure 39
1. Tie-down loops
Unloading the Machine
1. Lower the ramp, ensuring that the angle
between the ramp and the ground does not
exceed 15 degrees (
Figure 37 ).
2. Drive the machine forward down the ramp
(
Figure 38 ).
29