Toro TimeCutter 74780, Руководство оператора

Страница: 42 / 48

G015129
1
2
3
4
5
4
6
Figure 55
Mower decks with 1 blade
1. Idler pulley 4. Spring
2. Mower belt 5. Engine pulley
3. Outside pulley 6. Spring-removal tool
5. Route the new belt around the engine pulley and
mower pulleys (
Figure 55 .
6. Using a spring removal tool (Toro Part No. 92-5771),
install the idler spring over the deck hook and placing
tension on the idler pulley and the mower belt (
Figure
55 .
Cleaning
Cleaning under the Front of
the Machine
Service Interval: After each use—Check and clean the front
of the mower.
Remove debris under the front of the machine with
compressed air or by hand with a brush (
Figure 56 ).
Note:
Do not use water to clean under the front of the
machine, this can cause build up of debris.
Figure 56
Washing the Underside of the
Mower Deck
Service Interval: After each use—Clean the mower housing.
Important:
You can wash the machine with mild
detergent and water. Do not pressure wash the machine.
Avoid excessive use of water, especially near the control
panel, under the seat, around the engine, hydraulic
pumps, and motors.
Wash the underside of the mower after each use to prevent
grass buildup for improved mulch action and clipping
dispersal.
1. Park the machine on a level surface and disengage the
blade-control switch.
2. Engage the parking brake, shut off the engine, remove
the key, and wait for all moving parts to stop before
leaving the operating position.
3. Attach the hose coupling to the end of the mower
washout fitting, and turn the water on high (
Figure 57 ).
Note:
Spread petroleum jelly on the washout fitting
O-ring to make the coupling slide on easier and protect
the O-ring.
42