for damage. Make all necessary repairs before
resuming operation.
•
Before leaving the operating position, shut off the
engine and wait for all moving parts to stop.
•
If the engine has been running, it will be hot and
can severely burn you. Keep away from the hot
engine.
•
Operate the engine only in well-ventilated areas.
Exhaust gases contain carbon monoxide, which
is lethal if inhaled.
•
Check the grass catcher components and the
discharge chute frequently for any wear or
deterioration and replace them with genuine Toro
parts when necessary.
Slope Safety
•
Mow across the face of slopes; never up and
down. Use extreme caution when changing
direction on slopes.
•
Do not mow on excessively steep slopes. Poor
footing could cause a slip-and-fall accident.
•
Mow with caution near drop-offs, ditches, or
embankments.
Starting the Engine
1.
Hold the blade-control bar against the handle
(A of
).
2.
Pull the recoil-start handle lightly until you feel
resistance, then pull it sharply, and allow it to
return to the rope guide on the handle slowly (B
of
g230459
Figure 14
Note:
If the machine does not start after several
attempts, contact an Authorized Service Dealer.
Using the Self-Propel Drive
To operate the self-propel drive, simply walk with your
hands on the upper handle and your elbows at your
sides, and the machine will automatically keep pace
with you (
).
g233423
Figure 15
Note:
If the machine does not freely roll backward
after self-propelling, stop walking, hold your hands
in place, and allow the machine to roll a couple of
centimeters (inches) forward to disengage the wheel
drive. You can also try reaching just under the upper
handle to the metal handle and pushing the machine
forward a couple of centimeters (inches). If the
machine still does not roll backward easily, contact an
Authorized Service Dealer.
10
Содержание Super Recycler 21681
