Toro Super Recycler 20382, Руководство оператора

Страница: 11 / 72

repeat steps 3 through 5 until the oil level on
the dipstick is correct.
•
If the oil level is too high, drain the excess oil
until the oil level on the dipstick is correct. To
drain the excess oil, refer to
Changing the
Engine Oil (page 17) .
Important:
If the oil level in the crankcase
is too low or too high and you run the
engine, you may damage the engine.
6. Install the dipstick securely.
Adjusting the Cutting
Height
WARNING
Adjusting the cutting height may bring you
into contact with the moving blade, causing
serious injury.
• Stop the engine and wait for all moving
parts to stop.
• Do not put your fingers under the housing
when adjusting the cutting height.
CAUTION
If the engine has been running, the muffler
will be hot and can severely burn you. Keep
away from the hot muffler.
Adjust the cutting height as desired. Set all 4 wheels
to the same height.
Note:
To raise the machine, move all 4 cutting height
levers forward; to lower the machine, move them all
rearward (
Figure 13 ).
g189041
Figure 13
Adjusting the Handle
Height
You may raise or lower the handle to a position
comfortable for you.
Rotate the handle lock, move the handle to 1 of 3
positions, and lock the handle into position (
Figure
14 ).
g007284
Figure 14
1. Handle lock 2. Handle positions
Starting the Engine
1. Pull the blade-control bar to the handle ( Figure
15 ).
g003124
Figure 15
2. Pull the recoil-start handle ( Figure 16 ).
10