Toro SS 4200, Руководство оператора

Страница: 48 / 56

Removing the Mower Deck
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Lower the height-of-cut lever to the lowest
position.
4. Remove the hairpin cotter from the front support
rod, and remove the rod from the deck bracket
(
Figure 63 ).
g014635
Figure 63
1. Front support rod 3. Deck bracket
2. Locking nut
5. Carefully lower the front of the mower deck to
the ground.
6. Lift the mower deck and hanger brackets clear
of the rear lift rod and lower the mower carefully
to the ground (
Figure 64 ).
g005077
Figure 64
1. Mower deck 3. Rear lift rod
2. Hanger bracket
7. Slide the mower deck rearward to remove the
mower belt from the engine pulley.
8. Slide the mower deck out from underneath the
machine.
Note:
Retain all parts for future installation.
Installing the Mower Deck
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Slide the mower under the machine.
4. Lower the height-of-cut lever to the lowest
position.
5. Lift the rear of the mower deck and guide the
hanger brackets over the rear lift rod (
Figure 64 ).
6. Attach the front support rod to the mower deck
with the clevis pin and hairpin cotter (
Figure 63 ).
7. Install the mower belt onto the engine pulley;
refer to
Replacing the Mower Belt (page 41) .
48