Toro Spray Master, Руководство оператора

Страница: 45 / 88

3. Rotate the strainer bowl counterclockwise and
remove the bowl and screen from the body of
the strainer (
Figure 54 ).
Note:
Remove the strainer bowl by hand.
Note:
Replace the gasket or screen or both if
these parts are worn or damaged.
g311411
Figure 54
1. Strainer bowl 3. Screen
2. Gasket 4. Strainer body
4. Allow any residual chemical solution to drain
from the strainer body.
Note:
Dispose of the waste solution according
to local codes and the chemical manufacturer's
instructions.
5. Use a soft-bristle brush and clean water to clean
the screen and bowl.
6. Install the screen into the strainer body ( Figure
54 ).
7. Install the gasket and strainer bowl onto the
strainer body, and hand tighten the bowl (
Figure
54 ).
Cleaning the Sprayer Nozzles
Service Interval: After each use
1. Rotate the nozzle cap 90° counterclockwise and
remove the cap from the nozzle body (
Figure
55 ).
g311414
Figure 55
1. Nozzle body 3. Sprayer tip
2. Strainer 4. Nozzle cap
2. Remove the sprayer tip and strainer from the
nozzle body (
Figure 55 ).
Note:
Replace any worn or damaged nozzle
parts.
3. Use a soft-bristle brush and clean water to clean
the nozzle tip and strainer.
4. Assemble the strainer into the nozzle body
(
Figure 55 ).
5. Assemble the sprayer tip into the nozzle cap
(
Figure 55 ).
6. Install the tip and cap onto the nozzle body
(
Figure 55 ).
Note:
Use the slot to rotate the atomizer ( Figure
56 ) of the sprayer tip forward (in-line with the
flow-regulator case of the nozzle body).
45