Toro Sand Pro 2040Z, Руководство оператора

Страница: 27 / 60

Testing the Safety Interlock System
Service Interval: Before each use or daily
If the safety interlock system does not operate as described
below, have an Authorized Toro Distributor repair it
immediately.
1. Sit on the seat, move the control handles to the neutral
position, and set the parking brake.
2. Start the engine.
3. Get off the seat and slowly move each control handle
forward and backward.
Note:
The engine should stop in 1 to 3 seconds after
moving either control handle in either direction. If it
does not, correct the problem. Repeat steps
2 and 3 for
the other control handle.
4. Sitting on the seat, engage the parking brake. Move
either control handle out of the neutral-locked position.
Try starting the engine; the engine should not crank.
Repeat this step for the other control handle.
Driving the Machine
CAUTION
Operating the machine demands attention to
prevent tipping or loss of control.
• Use care when entering and leaving sand traps.
• Use extreme caution around ditches, creeks, or
other hazards.
• Use caution when operating the machine on a
steep slope.
• Reduce your speed when making sharp turns or
when turning on hillsides.
• Avoid sudden stops and starts.
• Do not go from reverse to full forward without
first coming to a complete stop.
CAUTION
The machine can spin very rapidly. If you misuse
the control handles, you may lose control of the
machine and injure someone or damage the
machine or other property.
• Use caution when making turns.
• Slow the machine down before making sharp
turns.
Using the Control Handles
Figure 24
1. Control handle
(neutral-locked position)
4. Backward
2. Center, unlocked position 5. Front of the machine
3. Forward
Driving the Machine Forward
Note:
The engine stops if you move the control handles
while the parking brake is set.
1. Release the parking brake; refer to Releasing the
Parking Brake (page 25) .
2. Move the control handles to the center, unlocked
position.
3. To go forward, slowly push the control handles forward
(
Figure 25 ).
To stop the machine, move the control handles to the
neutral position.
27