Toro REELMASTER 6700 D, Руководство оператора

Страница: 13 / 56

g006533
Figure 3
1. Pivot rod 2. Tipper support bracket
w/roller
Note:
The tipper bracket with the roller and the
tipper support brackets are not required when
operating the DPA cutting units (
Figure 3 ).
2. Disconnect the lift chains from the cutting units,
if attached.
Mounting the Lift Brackets and
Chains
Mount a chain bracket to each lift arm with a U-bolt
and 2 nuts. Position the brackets as follows:
Note:
Refer to Figure 4 to determine the lift arm
number being described.
g034112
Figure 4
1. Cutting unit 1 6. Cutting unit 6
2. Cutting unit 2 7. Cutting unit 7
3. Cutting unit 3 8. Reel motor
4. Cutting unit 4 9. Weight
5. Cutting unit 5
1. On lift arm numbers 1, 4, and 5, position the
chain brackets and U-bolts 38.1 cm (15 inches)
behind the center line of the pivot knuckle
(
Figure 5 ).
2. On lift arm numbers 1 and 5 the brackets should
be rotated to the right 10 degrees from vertical
(
Figure 5 ).
3. On lift arm number 4 the bracket should be
rotated to the left 10 degrees from vertical
(
Figure 5 ).
g020546
Figure 5
1. Lift arm number 5 =
38.1 cm (15 inches)
3. Lift arm numbers 1 and 5 =
10 degrees
2. Lift arm number 4 =
10 degrees
4. On lift arm numbers 2 and 3, position the
brackets and U-bolts 38.1 cm (15 inches) behind
the center line of the pivot knuckle (
Figure 6 ).
Note:
Rotate the brackets 45 degrees to the
outboard side of the machine.
13