Toro Reelmaster 5610-D, Руководство пользователя

Страница: 22 / 84

g003955
Figure 41
1. Traction pedal 4. Brake pedal
2. Mow/transport lever 5. Parking brake
3. Mow-speed limiter and
spacers 6. Tilt steering pedal
Mow/Transport Lever
Use the mow/transport lever ( Figure 41 ) to put the machine
into M
OW
mode or T
RANSPORT
mode. Push the lever
forward to select the M
OW
mode, and backward to select
the T
RANSPORT
mode.
Note:
The cutting units cannot be lowered when the
mow/transport lever is in the T
RANSPORT
position.
Mow-Speed Limiter
When the mow-speed limiter ( Figure 41 ) is flipped
up/forward it limits the mow speed and allow the cutting
units to be engaged. Each spacer adjusts the mowing
speed by 0.8 km/h (0.5 mph). The more spacers there are
on the top of the bolt, the slower the machine goes. Flip the
mow speed limiter backward to allow maximum transport
speed.
Brake Pedal
Press the brake pedal to stop the machine ( Figure 41 ).
Parking Brake
To engage the parking brake, push down on the brake
pedal and press the top forward to latch (
Figure 41 ). To
release the parking brake, press the brake pedal until the
parking-brake latch retracts.
Tilt-Steering Pedal
To tilt the steering wheel towards you, press the foot pedal
(
Figure 41 ) down, pull the steering tower toward you to the
most comfortable position, and release the pedal.
Engine-Speed Switch
The engine-speed switch has 2 modes to change the
engine speed (
Figure 42 ). By momentarily tapping the
switch, you can change the engine speed in 100 rpm
increments. If you hold the switch down, the engine
automatically moves to High or Low idle, depending on
which end of the switch you press.
g021208
Figure 42
1. Lower mow/raise control
lever 4. Enable/disable switch
2. Key switch 5. Engine-speed switch
3. InfoCenter 6. Headlight switch
Lower Mow/Raise Control Lever
This lever ( Figure 42 ) raises and lowers the cutting units,
and you use the lever to start and stop the cutting units
when the mow/transport lever is in the M
OW
mode and the
enable/disable switch is in the E
NABLE
position. You cannot
lower the cutting units when the mow/transport lever is in
the T
RANSPORT
position.
Key Switch
The key switch ( Figure 42 ) has 3 positions: O
FF
,
O
N
/P
REHEAT
, and S
TART
.
InfoCenter
The InfoCenter LCD display shows information about your
machine, such as the operating status, various diagnostics,
and other information about the machine (
Figure 42 ).
Enable/Disable Switch
Use the enable/disable switch ( Figure 42 ) in conjunction
with the lower mow/raise control lever to operate the cutting
units.
Headlight Switch
Pivot the switch downward to turn on the headlights ( Figure
42 ).
22