Toro Recycler 21772, Руководство оператора

Страница: 22 / 28

6. Carefully pour about 3/4 of the engine capacity
of oil into the oil-fill tube.
7. Wait 3 minutes for the oil to settle in the engine.
8. Wipe the dipstick clean with a clean cloth.
9. Insert the dipstick into the oil-fill tube, screw it in,
then remove the dipstick.
10. Read the oil level on the dipstick ( Figure 27 ).
•
If the oil level on the dipstick is too low,
carefully pour a small amount of oil into the
oil-fill tube, wait 3 minutes, and repeat steps
8 through 10 until the oil level on the dipstick
is correct.
•
If the oil level on the dipstick is too high,
drain the excess oil until the oil level on the
dipstick is correct.
Important:
If the oil level in the engine is too
low or too high and you run the engine, you
may damage the engine.
11. Install the dipstick into the oil-fill tube securely.
12. Recycle the used oil properly.
Replacing the Blade
Service Interval: Yearly—Replace the blade or have
it sharpened (more frequently if the
edge dulls quickly).
Important:
You will need a torque wrench to
install the blade properly . If you do not have a
torque wrench or are uncomfortable performing
this procedure, contact an Authorized Service
Dealer.
Examine the blade whenever you run out of fuel. If the
blade is damaged or cracked, replace it immediately.
If the blade edge is dull or nicked, have it sharpened
and balanced, or replace it.
WARNING
The blade is sharp; contacting the blade can
result in serious personal injury.
Wear gloves when servicing the blade.
1. Disconnect the spark-plug wire from the spark
plug; refer to
Preparing for Maintenance (page
20) .
2. Tip the machine onto its side with the air filter up.
3. Remove the 2 blade nuts and the stiffener
(
Figure 29 ).
g003134
Figure 29
1. Blade nuts 4. Blade driver
2. Stiffener 5. Anti-scalp disk
3. Blade 6. Blade-stop system shield
4. Remove the blade ( Figure 29 ).
5. Install the new blade ( Figure 29 ).
6. Install the stiffener you previously removed.
7. Install the blade nuts and torque them to 20
to 37 N∙m (15 to 27 ft-lb).
22