Toro Recycler 21465, Руководство оператора

Страница: 22 / 28

8. Wipe the dipstick clean with a clean cloth.
9. Insert the dipstick into the oil-fill tube, screw it in,
then remove the dipstick.
10. Read the oil level on the dipstick ( Figure 24 ).
•
If the oil level on the dipstick is too low,
carefully pour a small amount of oil into the
oil-fill tube, wait 3 minutes, and repeat steps
8 through 10 until the oil level on the dipstick
is correct.
•
If the oil level on the dipstick is too high,
drain the excess oil until the oil level on the
dipstick is correct.
Important:
If the oil level in the engine is too
low or too high and you run the engine, you
may damage the engine.
11. Install the dipstick into the oil-fill tube securely.
12. Recycle the used oil properly.
Replacing the Blade
Service Interval: Yearly
Important:
You will need a torque wrench to
install the blade properly . If you do not have a
torque wrench or are uncomfortable performing
this procedure, contact an Authorized Service
Dealer.
Examine the blade whenever you run out of fuel. If the
blade is damaged or cracked, replace it immediately.
If the blade edge is dull or nicked, have it sharpened
and balanced, or replace it.
WARNING
The blade is sharp; contacting the blade can
result in serious personal injury.
Wear gloves when servicing the blade.
1. Refer to Preparing for Maintenance (page 20) .
2. Tip the machine onto its side with the air filter up.
3. Use a block of wood to hold the blade steady
(
Figure 26 ).
g231389
Figure 26
4. Remove the blade, saving all mounting hardware
(
Figure 26 ).
5. Install the new blade and all mounting hardware
(
Figure 27 ).
g231390
Figure 27
Important:
Position the curved ends of the
blade to point toward the machine housing.
6. Use a torque wrench to tighten the blade bolt
to 82 N∙m (60 ft-lb).
22