Toro Recycler 20965, Руководство пользователя

Страница: 14 / 124

Using the Self-Propel Drive
To operate the self-propel drive, simply walk forward
or backward with your hands on the upper handle
and your elbows at your sides, and the machine will
automatically keep pace with you (
Figure 14 ).
g038503
Figure 14
Note:
If the machine does not freely roll forward
or backward after using the self-propel drive, stop
walking, hold your hands in place, and allow the
machine to roll a couple of centimeters (inches)
forward to disengage the wheel drive. You can also
try reaching just under the upper handle to the metal
handle and pushing the machine forward a couple
of centimeters (inches). If you are having issues
propelling in reverse, slightly lift the handle. If the
machine still does not roll backward easily, you may
need to adjust the self-propel drive; refer to
Adjusting
the Self-Propel Drive (page 22) . Otherwise, contact
an Authorized Service Dealer.
Shutting Off the Engine
Service Interval: Before each use or daily
To shut off the engine, release the blade-control bar.
Important:
When you release the blade-control
bar, both the engine and blade should stop within
3 seconds. If they do not stop properly, stop
using your machine immediately and contact an
Authorized Service Dealer.
Recycling the Clippings
Your machine comes from the factory ready to recycle
the grass and leaf clippings back into the lawn.
If the grass bag is on the machine and the
bag-on-demand lever is in the bagging position,
move the lever to the recycling position; refer to
Operating the Bag-on-Demand Lever (page 14) . If
the side-discharge chute is on the machine, remove
it; refer to
Removing the Side-Discharge Chute (page
14) .
Bagging the Clippings
Use the grass bag when you want to collect grass and
leaf clippings from the lawn.
If the side-discharge chute is on the machine, remove
it; refer to
Removing the Side-Discharge Chute (page
14) . If the bag-on-demand lever is in the recycling
position, move it to the bagging position; refer to
Operating the Bag-on-Demand Lever (page 14) .
Installing the Grass Bag
1. Raise and hold up the rear deflector ( Figure 15 ).
g208184
Figure 15
1. Rear deflector 3. Grass-bag pin (2)
2. Notches (2)
2. Install the grass bag, ensuring that the pins on
the bag rest in the notches on the handle (
Figure
15 ).
3. Lower the rear deflector.
Removing the Grass Bag
To remove the bag, reverse the steps in Removing
the Grass Bag (page 13) .
13