Toro Recycler 20960, Руководство пользователя

Страница: 21 / 96

8 through 10 until the oil level is at the Full mark
on the dipstick.
•
If the oil level is above the Full mark on the
dipstick, drain the excess oil until the oil level is at
the Full mark on the dipstick.
Important:
If the oil level in the engine is too
low or too high and you run the engine, you may
damage the engine.
11. Install the dipstick securely.
12. Recycle the used oil properly.
Replacing the Blade
Service Interval: Yearly
Important:
You will need a torque wrench to install the
blade properly. If you do not have a torque wrench or
are uncomfortable performing this procedure, contact
an Authorized Service Dealer.
Examine the blade whenever you run out of fuel. If the blade
is damaged or cracked, replace it immediately. If the blade
edge is dull or nicked, have it sharpened and balanced, or
replace it.
WARNING
The blade is sharp; contacting the blade can result
in serious personal injury.
Wear gloves when servicing the blade.
1. Refer to Preparing for Maintenance (page 17) .
2. Tip the machine onto its side with the air filter up.
3. Use a block of wood to hold the blade steady ( Figure
34 ).
g005454
Figure 34
4. Remove the blade, saving all mounting hardware
(
Figure 34 ).
5. Install the new blade and all mounting hardware
(
Figure 35 ).
g005455
Figure 35
Important:
Position the curved ends of the blade
to point toward the machine housing.
6. Use a torque wrench to tighten the blade bolt to
82 N∙m (60 ft-lb).
Important:
A bolt torqued to 82 N∙m (60 ft-lb) is
very tight. While holding the blade with a block
of wood, put your weight behind the ratchet or
wrench and tighten the bolt securely. This bolt is
very difficult to overtighten.
19