Toro Recycler 20960, Руководство пользователя

Страница: 14 / 96

Using the Traction-Assist
Handle
The traction-assist handle ( Figure 20 ) allows you to use your
hands to control the speed of the machine instead of your
walking speed. This is helpful for turning tight corners
and going up hills, where you want the machine to move
but cannot move yourself. It is also useful for mowing at
maximum speed.
g027441
Figure 20
1. Traction-assist handle
1. Reach forward with your fingertips and grasp the
corners of the traction-assist handle (
Figure 21 ).
g027442
Figure 21
2. Squeeze the 2 handles together until the machine
achieves your desired ground speed.
3. Release the traction-assist handle when you no longer
need it.
Important:
The machine will continue to
self-propel until you release the traction-assist
handle and stop walking.
Shutting Off the Engine
Service Interval: Before each use or daily
To shut off the engine, release the blade-control bar.
Important:
When you release the blade-control bar,
both the engine and blade should stop within 3 seconds.
If they do not stop properly, stop using your machine
immediately and contact an Authorized Service Dealer.
Recycling the Clippings
Your machine comes from the factory ready to recycle the
grass and leaf clippings back into the lawn.
If the grass bag is on the machine and the bag-on-demand
lever is in the bagging position, move the lever to the recycling
position; refer to
Operating the Bag-on-Demand Lever (page
13) . If the side-discharge chute is on the machine, remove it;
refer to Removing the Side-Discharge Chute (page 13) .
Bagging the Clippings
Use the grass bag when you want to collect grass and leaf
clippings from the lawn.
If the side-discharge chute is on the machine, remove it; refer
to
Removing the Side-Discharge Chute (page 13) . If the
bag-on-demand lever is in the recycling position, move it to
the bagging position; refer to
Operating the Bag-on-Demand
Lever (page 13) .
Installing the Grass Bag
1. Raise and hold up the rear deflector ( Figure 22 ).
g033379
Figure 22
1. Rear deflector 3. Grass-bag pin (2)
2. Notches (2)
2. Install the grass bag, ensuring that the pins on the bag
rest in the notches on the handle (
Figure 22 ).
3. Lower the rear deflector.
12