Toro Recycler 20958, Руководство оператора

Страница: 6 / 96

Setup
Important:
Remove and discard the protective plastic
sheet that covers the engine.
1
Installing the Blade-Control
Bar
No Parts Required
Procedure
Install the blade-control bar into the upper handle ( Figure 4 ).
g003116
Figure 4
2
Assembling and Unfolding the
Handle
No Parts Required
Procedure
1. Install the handle ends onto the mower housing so that
the pin attached to each handle bracket is in the lower
hole of its related handle end (
Figure 5 ).
g032866
Figure 5
1. Pin 2. Handle end
Note:
The pins do not show through the holes in the
handle ends when the handle is in the folded position.
2. Remove and save the 2 handle knobs and 2 carriage
bolts from the handle brackets (
Figure 6 ).
g032865
Figure 6
1. Handle knob 2. Carriage bolt
3. Unfold the handle to the operating position by rotating
it rearward (
Figure 7 ).
4