Toro Recycler 20954, Руководство пользователя

Страница: 12 / 104

2. Pull the recoil-start handle ( Figure 18 ) lightly
until you feel resistance, then pull it sharply, and
allow it to return to the rope guide on the handle
slowly.
g188707
Figure 18
Note:
If the machine does not start after several
attempts, contact an Authorized Service Dealer.
Using the Self-Propel Drive
•
To engage the self-propel drive: Squeeze the
self-propel-drive bar against the handle and hold
it (
Figure 19 ).
g017321
Figure 19
1. Self-propel-drive bar
Note:
The maximum self-propel-drive speed is
fixed. To reduce the speed, increase the space
between the self-propel-drive bar and the handle.
•
To disengage the self-propel-drive: release the
self-propel-drive bar.
Note:
The machine comes with freewheeling
clutches that make it easier to pull the machine
rearward. To disengage the clutches, you
may need to push the machine forward about
2.5 cm (1 inch) or more after you release the
self-propel-drive bar.
Shutting Off the Engine
Service Interval: Before each use or daily—Ensure
that the engine shuts off within
3 seconds after releasing the
blade-control bar.
To shut off the engine, release the blade-control bar.
Important:
When you release the blade-control
bar, both the engine and blade should stop within
3 seconds. If they do not stop properly, stop
using your machine immediately and contact an
Authorized Service Dealer.
Recycling the Clippings
Your machine comes from the factory ready to recycle
the grass and leaf clippings back into the lawn.
If the grass bag is on the machine, remove it;
refer to
Removing the Grass Bag (page 12) . If the
side-discharge chute is on the machine, remove it;
refer to
Removing the Side-Discharge Chute (page
12) .
Bagging the Clippings
Use the grass bag when you want to collect grass and
leaf clippings from the lawn.
If the side-discharge chute is on the machine, remove
it; refer to
Removing the Grass Bag (page 12) .
11