Toro Recycler 20372, Руководство оператора, Страница: 18 / 28

Cleaning under the Machine
Service Interval: Before each use or daily
For best results, clean the machine soon after you
have completed mowing.
1. Move the machine onto a flat paved surface.
2. Shut off the engine and wait for all moving parts
to stop before leaving the operating position.
3. Lower the machine to its lowest cutting-height
setting. Refer to
Adjusting the Cutting Height
(page 12) .
4. Wash out the area under the rear door where the
clippings go from the underside of the machine
to the grass bag.
Note:
Wash out the area with the
bag-on-demand (if equipped) in both the fully
forward and fully rearward positions.
5. Attach a garden hose that is connected to a
water supply to the washout port (
Figure 21 ).
g194695
Figure 21
1. Washout port
6. Turn the water on.
7. Start the engine and run it until the clippings no
longer come out from under the machine.
8. Shut off the engine.
9. Shut off the water and disconnect the garden
hose from the machine.
10. Start the engine and run it for a few minutes to
dry the underside of the machine to prevent it
from rusting.
11. Shut off the engine and allow it to cool before
storing the machine in an enclosed area.
Folding the Handle
WARNING
Folding or unfolding the handle improperly
can damage the cables, causing an unsafe
operating condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an
Authorized Service Dealer.
1. Remove the electric-start button as shown in
Figure 22 (electric-start model only).
g035929
Figure 22
1. Electric starter 2. Electric-start button
2. Remove and save the 2 handle knobs and 2
carriage bolts from the handle brackets (
Figure
23 ).
Important:
Route the cables to the outside
of the handle knobs as you fold the handle.
18