Toro Recycler 20357, Руководство оператора

Страница: 20 / 72

g206313
Figure 28
5. After draining the used oil, return the machine to
the operating position.
6. Carefully pour about 3/4 of the engine capacity
of oil into the oil-fill tube.
7. Wait about 3 minutes for the oil to settle in the
engine.
8. Wipe the dipstick clean with a clean cloth.
9. Insert the dipstick into the oil-fill tube, but do not
screw it in, then remove the dipstick.
10. Read the oil level on the dipstick ( Figure 27 ).
•
If the oil level on the dipstick is too low,
carefully pour a small amount of oil into the
oil-fill tube, wait 3 minutes, and repeat steps
8 through 10 until the oil on the dipstick is at
the correct level.
•
If the oil level on the dipstick is too high, drain
the excess oil until the oil on the dipstick is at
the correct level.
Important:
If the oil level in the engine is too
low or too high and you run the engine, you
may damage the engine.
11. Install the dipstick into the oil-fill tube securely.
12. Recycle the used oil properly.
Replacing the Blade
Service Interval: Yearly
Important:
You will need a torque wrench to
install the blade properly . If you do not have a
torque wrench or are uncomfortable performing
this procedure, contact an Authorized Service
Dealer.
Examine the blade whenever you run out of fuel. If the
blade is damaged or cracked, replace it immediately.
If the blade edge is dull or nicked, have it sharpened
and balanced, or replace it.
WARNING
The blade is sharp; contacting the blade can
result in serious personal injury.
Wear gloves when servicing the blade.
1. Refer to Preparing for Maintenance (page 17) .
2. Tip the machine onto its side with the air filter up.
3. Use a block of wood to hold the blade steady
(
Figure 29 ).
g005454
Figure 29
4. Remove the blade, saving all mounting hardware
(
Figure 29 ).
5. Install the new blade and all mounting hardware
(
Figure 30 ).
19