Figure 26
4.
Slowly
pour oil into the oil fill tube until the oil level
reaches the
Full
line on the dipstick (Figure 27).
Do not
overfill.
(Max. fill: 20 oz., type: SAE 30W detergent
oil with an API service classification of SF, SG, SH, SJ,
SL, or higher.)
Figure 27
5. Install the dipstick securely.
6. Dispose of the used oil properly at a local recycling
center.
Charging the Battery
Models 20074 and 20074A only
Warning
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals known
to the State of California to cause cancer and
reproductive harm. Wash hands after handling.
Charge the battery for 24 hours initially, then monthly
(every 25 starts) or as needed. Always use the charger in a
sheltered area and charge the battery at room temperature
(70° or 22° C) whenever possible.
1. Connect the charger to the mower wire harness located
below the ignition key (Figure 28).
Figure 28
2. Plug the charger into a wall outlet.
Note:
When the battery no longer holds a charge,
recycle or dispose of the lead-acid battery according to
local codes.
Replacing the Fuse
Models 20074 and 20074A only
If the battery does not charge or the engine does not run
with the electric starter, the fuse may be blown. Replace it
with a 40-amp plug-in type fuse. Refer to Installing the Fuse.
17
