Toro ProPass 200, Руководство по установке

Страница: 7 / 16

g013908
Figure 12
1. Hydraulic pump 2. Hydraulic hose #4
39. On the SH version, model 44701, remove the
fasteners securing the cover to the front of the
ProPass and set the cover aside (
Figure 13 ).
g013845
Figure 13
1. Cover
40. Identify the pressure and return connections on
the ProPass base model. Refer to
Figure 14
for the SH versions and Figure 15 for the EH
versions.
g014215
Figure 14
1. Pressure 2. Return
g259001
Figure 15
1. Return 2. Pressure
41. If pressure and return hoses were previously
installed at the locations shown in
Figure 14 and
Figure 15 , remove them.
Note:
Make sure the hoses do not contact any
hot, sharp or moving parts. Try to attain as much
clearance from the muffler as possible.
42. Connect the hydraulic hoses to the hydraulic
control panel. Refer to
Figure 14 and Figure 16
on the SH versions and Figure 15 and Figure
17 on the EH versions.
g013867
Figure 16
1. Hose routing
7