Toro ProLine 30180, Руководство оператора

Страница: 20 / 44

Set-Up
18
Activate the Battery
Bulk electrolyte with 1.260 specific gravity must be
purchased from a local battery supply outlet.
1. If already installed, remove the battery from the
holder.
POTENTIAL HAZARD
•
Battery electrolyte contains sulfuric acid
which is a deadly poison and it causes
severe burns.
WHAT CAN HAPPEN
•
If you carelessly drink electrolyte you could
die or if it gets onto your skin you will be
burned.
HOW TO AVOID THE HAZARD
•
Do not drink electrolyte and avoid contact
with skin, eyes or clothing. Wear safety
glasses to shield your eyes and rubber
gloves to protect your hands.
•
Fill the battery where clean water is always
available for flushing the skin.
•
Follow all instructions and comply with all
safety messages on the electrolyte container.
2. Remove filler caps from the battery. Slowly pour
electrolyte into each cell until the electrolyte
level is up to the lower part of the tube (Fig. 15).
1
2
3
1262
Figure 15
1. Filler caps
2. Electrolyte
3. Lower part of the tube
3. Leave the covers off and connect a 3 to 4 amp
battery charger to the battery posts (Fig. 16).
Charge the battery at a rate of 4 amperes or less
for 4 hours (12 volts).
4
1
2
3
1254
Figure 16
1. Positive post
2. Negative post
3. Charger red (+) wire
4. Charger black (–) wire