Toro procore sr54, Руководство оператора

Страница: 14 / 40

g010807
Figure 13
5. Measure the distance from the locking groove
at the end of the traction unit PTO shaft to the
locking groove at the aerator gearbox shaft
(
Figure 14 ).
Record this measurement here:
E
XAMPLE
: 70
CM
(27-1/2
INCHES
)
g237883
Figure 14
1. Measure here 2. Locking groove
6. Measure the distance from the center of locking
pin ball at the end of the PTO shaft to the center
of the locking pin on the other end (
Figure 15 ).
Record this measurement here:
E
XAMPLE
: 81
CM
(32
INCHES
)
g237882
Figure 15
1. Measure here
7. Using the smaller of the 2 measurements in
Figure 14 and Figure 12 , subtract that distance
from the distance in Figure 15 . Example: 81 cm
(32 inches) minus 67 cm (26-1/2 inches) equals
14 cm (5-1/2 inches).
8. The example measurements show that the shaft
is 14 cm (5-1/2 inches) too long. Add an extra
1.2 cm (1/2 inch) to ensure that the PTO shaft
does not bottom out when you lift the aerator
to its highest position.
E
XAMPLE
: 14
CM
(5-1/2
INCHES
)
PLUS
1.2
CM
(1/2
INCH
)
EQUALS
15
CM
(6
INCHES
)
9. Fully slide together the PTO shaft tubes. Verify
that the
inside tube does not protrude into the
cross and bearing section of the outer tube
(
Figure 16 ). If this happens, you need to cut off
more of the inside tube—proceed to next step.
10. Measure the distance the inside tube protrudes
into the cross and bearing section of the outer
tube (
Figure 16 ). Add this distance to the
dimension attained in step 8.
g237881
Figure 16
1. Cut off 2. Inside tube
11. Separate the 2 halves of the PTO shaft ( Figure
17 ).
12. Measure the distance from the end of each tube
to its safety shield (
Figure 17 ).
Record the measurements here
and .
g237887
Figure 17
13. Using the dimensions determined in step 8 ,
locate, mark, and cut off the shield and tube
from each PTO half (
Figure 18 and Figure 19 ).
14