Toro Pro Sweep 07068, Руководство оператора

Страница: 22 / 40

g011012
Figure 20
1. Open notches 4. 6 to 13 mm (1/4 to 1/2 inch)
2. Brush length 5. Brush direction
3. Center brush shaft height
1. Move the machine to a level surface.
2. Raise the hopper and install the hopper safety support. Refer to Using the Hopper Safety Support
(page 24) .
3. Loosen the locknut on the height adjustment key ( Figure 21 ) so that you can pull it out approximately
13 mm (1/2 inch).
g011013
Figure 21
1. Locknut 4. Roller-height adjusting plate
2. Height-adjusting key tab 5. Roller-scraper adjusting nuts
3. Roller-height adjusting nuts
4. Loosen the roller-height adjustment locknuts ( Figure 21 ).
5. Pull out the height-adjusting key and move the rear roller up or down by sliding the roller-height adjusting
plate to the desired height (
Figure 21 ).
6. Tighten the locknuts to secure the adjustment.
7. Repeat the procedure on the opposite end of the brush; ensure that the adjustments are the same.
22