Toro PowerPlex 51491, Руководство оператора

Страница: 11 / 16

4. Slide the battery pack into the charger until it is
fully seated (
Figure 9 ).
g194423
Figure 9
1. Charger venting areas 3. Right indicator light
2. Left indicator light
5. To remove the battery pack, slide the battery
backward out of the charger.
6. Refer to the following table to interpret the LED
indicators on the battery charger.
Left Light Right Light Indicates
Off Red
Charger is on; no battery
pack inserted
Red Red Battery pack is charging
Green Red Battery pack is charged
Orange Red Battery pack is too warm
Red Blinking Red Replace the battery pack
Operating Tips
•
Use the power tool for cutting in either direction in
a slow, sweeping action from side to side.
•
Stand so that you are stable and balanced on both
feet. Do not overreach.
•
Inspect and clear the area of any hidden objects.
•
Never use the hedge trimmer near power lines,
fencing, posts, buildings, or other immovable
objects.
•
Never use a blade after hitting a hard object
without first inspecting it for damage. Do not use if
it is damaged.
•
Never touch blades or service unit with the power
supply connected.
•
Do not force the hedge trimmer through heavy
shrubbery. This can cause the blades to bind and
slow down. If the blades slow down, reduce the
pace.
•
Do not attempt to cut stems or twigs that are larger
than 18 mm (0.71 inch) in diameter, or those
obviously too large to feed into the cutting blade.
Use a non-powered hand saw or pruning saw to
trim large stems.
•
If the blades do become jammed, stop the motor,
allow the blades to stop, and remove the battery
before attempting to remove the obstruction.
CAUTION: The blades may move slightly due
to residual tension.
•
If desired, you can use a string to help cut your
hedge level. Decide how high you want the hedge.
Stretch a piece of string along the hedge at the
desired height. Trim the hedge just above the
guide line of string.
•
Wear gloves when trimming thorny or prickly
growth. When trimming new growth, use a wide
sweeping action so that the stems are fed directly
into the cutting blade.
11