Toro Power Max 724 OE, Руководство оператора

Страница: 15 / 28

engine can also be stopped by pulling the ignition key
outward to the middle position.
STOP
G016505
Figure 26
2. Wait for all moving parts to stop before leaving the
operating position.
3. Remove the ignition key to prevent accidental starting.
4. Close the fuel shutoff valve by rotating it clockwise
(
Figure 27 ).
G016499
Figure 27
5. Pull the recoil starter 3 or 4 times. This helps prevent
the recoil starter from freezing up.
Operating the Traction Drive
CAUTION
If the traction drive is not properly adjusted, the
machine may move in the direction opposite of
what you intended, causing injury and/or property
damage.
Carefully check the traction drive and adjust it
properly, if necessary; refer to Checking the Traction
Drive Operation in Setup for more information.
Important:
If the machine moves when the traction
lever is in the released position, check the traction cable
(refer to Checking and Adjusting the Traction Cable) or
take the machine to an Authorized Service Dealer for
service.
1. To engage the traction drive, squeeze the left hand
(traction) lever to the hand-grip (
Figure 28 ).
Figure 28
2. To stop the traction drive, release the traction lever.
Operating the Speed Selector
The speed selector has 6 forward and 2 reverse gears. To
change speeds, release the traction lever and shift the speed
selector lever to the desired position (
Figure 29 ). The lever
locks in a notch at each speed selection.
Figure 29
15