Toro Power Max 39924, Руководство оператора

Страница: 25 / 32

Checking and Adjusting the
Auger/Impeller Cable
Service Interval: After the first 2 hours—Inspect the
auger/impeller cable and adjust it if
necessary.
Yearly—Inspect the auger/impeller cable and
adjust or replace it if necessary.
1. Loosen the jam nut ( Figure 31 ).
2. Engage the auger/impeller lever and hold it in
place (
Figure 30 ).
g360687
Figure 30
3. Loosen or tighten the turnbuckle to adjust the
spring length to 6.6 cm (2-3/5 inches) as shown
in
Figure 31 .
g371834
Figure 31
1. Turnbuckle 3. Spring
2. Jam nut
4. 6.6 cm (2-3/5 inches) while
the auger/impeller lever is
held down.
4. Tighten the jam nut ( Figure 31 ), ensuring that
there is slight tension on the cable.
5. Turn on the machine and attempt to engage the
auger/impeller drive without moving the lock
switch back; if the auger rotates, loosen the
turnbuckle so that the auger does not engage.
6. If the auger/impeller cable is properly adjusted
but a problem remains, contact an Authorized
Service Dealer.
25