Toro MX 5050, Руководство оператора

Страница: 28 / 52

Pre-Maintenance
Procedures
Raising the Seat
Make sure that the motion-control levers are locked in
the P
ARK
position. Lift the seat forward.
You can access the following components by raising
the seat:
•
Serial plate
•
Service decal
•
Seat-adjustment bolts
•
Fuel filter
•
Battery and battery cables
Lubrication
Greasing the Bearings
Service Interval: Every 25 hours—Grease all
lubrication points.
Grease Type: No. 2 lithium grease
1. Park the machine on a level surface and
disengage the blade-control switch.
2. Move the motion-control levers outward to the
P
ARK
position, shut off the engine, remove the
key, and wait for all moving parts to stop before
leaving the operating position.
3. Clean the grease fittings ( Figure 26 and Figure
27 ) with a rag.
Note:
Make sure to scrape any paint off the
front of the fitting(s).
g032432
Figure 26
1. Front caster tire
decal106-8717
Figure 27
Located on the seat-pan underside
1. Read the instructions
before servicing or
performing maintenance.
3. Grease every 25 operating
hours.
2. Check the tire pressure
every 25 operating hours. 4. Engine
4. Connect a grease gun to each fitting ( Figure 26
and Figure 27 ).
5. Pump grease into the fittings until grease begins
to ooze out of the bearings.
28