Toro Multi Pro ExcelaRate 5800-G, Руководство оператора

Страница: 63 / 88

Charging the Battery
Important:
Always keep the battery fully charged.
This is especially important to prevent battery
damage when the temperature is below 32°F (0°C).
1. Remove the battery from the chassis; refer to
Removing the Battery (page 62) .
2. Connect a 3 to 4 A battery charger to the battery
posts and charge the battery at a rate of 3 to 4 A
for 4 to 8 hours (12 V).
Important:
Do not overcharge the battery.
3. Install the battery in the chassis; refer to
Installing the Battery (page 62) .
Storing the Battery
If the machine will be stored for more than 30 days,
remove the battery and charge it fully. Either store
it on a shelf or on the machine. Leave the cables
disconnected if it is stored on the machine. Store
the battery in a cool atmosphere to avoid quick
deterioration of the charge in the battery. To prevent
the battery from freezing, ensure that it is fully
charged.
Drive System
Maintenance
Inspecting the Wheels/Tires
Service Interval: After the first 8 hours—Torque the
wheel-lug nuts.
Every 100 hours—Torque the wheel-lug nuts.
Every 100 hours—Inspect the condition and
wear of the tires.
Torque the front lug nuts to 75 to 102 N∙m (55 to 75
ft-lb) and the rear lug nuts to 95 to 122 N∙m (75 to
90 ft-lb).
Operating accidents, such as hitting curbs, can
damage a tire or rim and also disrupt wheel alignment,
so inspect tire condition after an accident.
Changing the
Planetary-Gearbox Fluid
Service Interval: After the first 8 hours
Every 400 hours
Use high quality, SAE 85W-140 weight gear lube.
1. Position the sprayer on a level surface with the
rear wheels positioned for draining (
Figure 77 ).
g002244
Figure 77
1. Drain plugs
2. Set the parking brake, stop the pump, stop the
engine, and remove the key from the starter
switch.
3. Place a drain pan under the drain plugs and
remove them from the wheel (
Figure 77 ).
4. Place a pan under the inner drain plug and
remove it (
Figure 78 ).
63