Toro Multi Pro 5800, Руководство оператора

Страница: 30 / 36

Fault Code Table (cont'd.)
Fault ID Affected Component or
System Description Recommended Action
3 Main power relay fault The main power relay is not
supplying current.
4 Charging system fault Alternator voltage is too high or
too low.
14 Software version incompatibility The software versions are
mismatched
17 Starter timeout The starter was engaged too
long.
18 Taction pedal neutral switch The traction pedal switch does
not match ground speed.
Call your Authorized Toro
Service Distributor.
19 Flow-rate meter There is no signal from flow-rate
meter when spraying. Spray in the manual mode; Call
your Authorized Toro Service
Distributor.
41 Sprayer pump-control valve TEC controller electrical
problem. Call your Authorized Toro
Service Distributor.
Maintenance
Service Screens
1. To access the Service screen press button 2
on the Main Menu screen to navigate to the
SERVICE
option ( Figure 79 ); refer to Accessing
the Main Menu Screen (page 3) .
g192026
Figure 79
2. Press button 4 to select
SERVICE
sub-menu
( Figure 79 ).
This screen displays and allows you to display
hours and flow rate information.
Viewing the Service Hours
1. Press button 1 or 2 on the Service screen until
you reach the
HOURS
option ( Figure 80 ).
g192029
Figure 80
2. Press button 4 to select the Hours entry ( Figure
80 ).
3. Use the counter information ( Figure 81 )
displayed on the screen to determine the
following:
30