g193543
g193544
Figure 74
4.
Press buttons 3 or 4 to change the value of the
correction factor (
).
5.
Press button 5 to save your settings and exit
the
MANUAL CAL ENTRY
screen, and return to the
CALIBRATE
screen (
).
During Operation
InfoCenter Spray Area
Screens
Use the area screens to get information about the
following:
•
Area sprayed (acres, hectares, or 1000 ft
2
)
•
Volume sprayed (US gallon or liters)
Using the Total Area Screen
•
Use the Total Area screen to track the total number
of acres and gallons that you have sprayed across
all areas since the total area and total area volume
information was last reset.
•
You can use information on the total area screen to
track the amount of area and amount of chemical
sprayed for the job site.
•
Total area and total volume sprayed information
accumulates until you reset it. Press and hold
button 4 to reset the total area and total volume
information.
Important:
Resetting the total area and total
volume information at the total-area screen
resets all sub-area and sub-area volume
information for active and inactive sub-areas.
1.
From the Home screen, momentarily press and
hold any button to open the menu bar (
and
g194882
Figure 75
26
