Toro Multi Pro 5800-D, Руководство оператора

Страница: 83 / 92

Installing the Agitation-Manifold
Valve
1. Align the flange of the agitation-bypass valve,
1 gasket, and the end-cap-fitting flange of the
agitation-valve manifold (
Figure 115 A).
Note:
If needed, loosen the mounting hardware
for the pressure-filter head as needed to provide
clearance.
g032551
Figure 115
1. Flange (pressure-filter
head) 5. Gasket
2. Flange (agitation-bypass
valve) 6. Quick connect
3. Flange (reducer coupling) 7. Manifold (agitation valve)
4. Flange clamp 8. Flange
(manifold—agitation
valve)
2. Assemble the agitation-bypass valve, gasket,
and agitation-valve manifold with a clamp
tightened hand-tight (
Figure 115 A).
3. Align a gasket between the flanges of the
pressure-filter head and the agitation-valve
manifold (
Figure 115 B).
4. Assemble the pressure-filter head, gasket, and
agitation-valve manifold with a clamp tightened
hand-tight (
Figure 115 B).
5. Align a gasket between the flanges of the
agitation-valve manifold and the reducer
coupling (
Figure 115 B).
6. Assemble the agitation-valve manifold, gasket,
and reducer coupling with a clamp tightened
hand-tight (
Figure 115 B).
7. Align a gasket between the flanges of the
agitation-valve manifold and the adapter fitting
for the agitation-throttle valve (
Figure 115 C).
8. Assemble the agitation-valve manifold, gasket,
and adapter fitting with a clamp tightened
hand-tight (
Figure 115 C).
9. If you loosened the mounting hardware for the
pressure-filter head, tighten the nut and bolt to
1978 to 2542 N∙cm (175 to 225 in-lb).
Installing the Section-Manifold
Valve
1. Insert the upper end-cap fitting of the manifold
valve into the bypass fitting (
Figure 116 A).
Note:
If needed, loosen the mounting hardware
for the bypass valve as needed to provide
clearance.
g032552
Figure 116
1. Flange (reducer coupling) 6. Socket (outlet fitting)
2. Socket (bypass fitting) 7. Retainer
3. Bypass valve 8. Flange (manifold—section
valve)
4. Flange (adjacent
manifold—agitation valve) 9. Gasket
5. End-cap fitting
(manifold-valve assembly) 10. Flange clamp
2. Secure the end-cap fitting to the bypass fitting
by inserting a retainer into the socket of the
bypass fitting (
Figure 116 A).
83