Toro Multi Pro 5800-D, Руководство оператора

Страница: 57 / 92

g028155
Figure 70
1. Oil-filler cap
4. Install the oil-filler cap.
5. Install the dipstick firmly in place.
Changing the Engine-Oil Filter
1. Remove the forward heat shield; refer to
Removing the Forward Heat Shield (page 50) .
2. Raise the seats.
CAUTION
Components under the seat will be hot
if the sprayer has been running. If you
touch hot components, you may be
burned.
Allow the sprayer to cool before
performing maintenance or touching
components under the hood.
3. Align a drain pan under the engine-oil filter
(
Figure 71 ).
g028169
Figure 71
1. Drain plug 2. Engine-oil filter
4. Remove the old oil filter ( Figure 71 ).
Note:
Dispose of the used oil filter at a certified
recycling center.
5. Clean the surface of the oil-filter adapter of the
engine with a rag.
6. Fill the oil filter with the specified oil.
Note:
Allow the filter element to saturate with
oil.
7. Apply a thin coat of the specified oil to the rubber
gasket on the replacement oil filter.
8. Install the oil filter to the filter adapter, turn the oil
filter clockwise until the rubber gasket contacts
the filter adapter, and then tighten the filter an
additional 1/2 turn (
Figure 71 ).
Note:
Do not overtighten the oil filter.
9. Wipe clean any residual oil.
Changing the Engine Oil
1. Align a drain pan under the drain plug ( Figure
71 ).
2. Remove the drain plug ( Figure 71 ) and allow the
oil to drain completely.
Note:
Check the drain-plug seal for wear
and damage; replace the seal if it is worn or
damaged.
Note:
Dispose of the used oil at a certified
recycling center.
3. Install the drain plug into the drain port of the
engine-oil pan and tighten the plug to 33 to 37
N∙m (24 to 27 ft-lb).
4. Tilt the passenger seat forward and align the
prop rod into the detent in the prop-rod-guide
slot.
5. Remove the oil-filler cap from filler neck of the
valve cover of the engine (
Figure 72 ) and slowly
pour approximately 80% of the specified amount
of oil into filler neck.
g028155
Figure 72
1. Oil-filler cap
57