Toro Multi Pro 41240, Руководство оператора

Страница: 84 / 96

Assembling the Manifold Valve
Operator supplied material: Clear silicone grease.
Important:
Use only silicone grease when
assembling the valve.
1. Check the condition of the outlet fitting O-rings
(section valve manifold only), end cap O-rings,
back seating O-rings, and ball seat for damage
or wear (
Figure 123 and Figure 124 ).
Note:
Replace any damaged or worn O-rings
or seats.
2. Apply silicone grease to the valve stem and
insert it into the valve stem seat (
Figure 123 and
Figure 124 ).
3. Install the valve stem and seat into the manifold
and secure the stem and seat with the stem
retainer (
Figure 123 and Figure 124 ).
4. Ensure that the back seating O-ring and the ball
seat are aligned and seated into the end-cap
fitting (
Figure 123 and Figure 124 )
5. Install the end-cap fitting assembly onto the
manifold body until the flange of the end-cap
fitting touches the manifold body (
Figure 123
and Figure 124 ), then turn the end-cap fitting an
additional 1/8 to 1/4 turn.
Note:
Use caution so as not to damage the end
of the fitting.
6. Insert the ball into the valve body ( Figure 125 ).
Note:
The valve stem should fit inside the ball
drive slot. If the valve stem does not fit, adjust
the position of the ball (
Figure 125 ).
g027565
Figure 125
7. Turn the valve stem assembly so that the valve
is closed (
Figure 122 B)
8. Repeat steps 4 and 5 for the other end-cap
fitting assembly.
Installing the Rate Control
Manifold Valve
1. Align a gasket between the flanges of the rate
control valve manifold and the pressure filter
head (
Figure 126 A).
Note:
If needed, loosen the mounting hardware
for the pressure filter head as needed to provide
clearance.
g238670
Figure 126
1. Locknut (1/4
inch) 5. Gasket 9. Coupling
(manifold-valve)
2. Valve mount 6. Flange clamp 10. Socket (outlet
fitting)
3. Flange
(agitation-valve) 7. Flange
(pressure filter
head) 11. Retainer
4. Flanged-head
bolt (1/4 x 3/4
inch) 8. Flange (rate
control valve)
2. Assemble the rate control valve manifold,
gasket, and pressure filter head with a flange
clamp and tighten by hand (
Figure 126 A).
3. Align a gasket between the flanges of the rate
control valve and the agitation-valve manifold
(
Figure 126 A).
84