Toro Multi Pro 41240, Руководство оператора

Страница: 64 / 96

g033578
Figure 95
1. Screen vane 2. Suction strainer
5. Clean the suction filter with clean water.
Important:
Replace the filter if it is damaged
or cannot be cleaned.
6. Insert the suction filter into the filter housing until
the filter is fully seated.
7. Align the hose and hose fitting to the filter
housing at the top of the tank, and secure fitting
and housing with the retainer that you removed
in step
2 .
Cleaning the Pressure Filter
Service Interval: Before each use or daily—Clean
the pressure filter. Clean the
pressure filter (more often when
using wettable powders).
1. Park the machine on a level surface, engage the
parking brake, shut off the sprayer pump, shut
off the engine, and remove the key.
2. Align a drain pan under the pressure filter
(
Figure 96 ).
g033582
Figure 96
1. Filter head 4. Gasket (drain plug)
2. Gasket (bowl) 5. Drain cap
3. Filter element 6. Bowl
3. Rotate the drain cap counterclockwise and
remove it from the bowl of the pressure filter
(
Figure 96 ).
Note:
Allow the bowl to drain completely.
4. Rotate the bowl counterclockwise and remove
the filter head (
Figure 96 ).
5. Remove the pressure filter element ( Figure 96 ).
6. Clean the pressure filter element with clean
water.
Important:
Replace the filter if it is damaged
or cannot be cleaned.
7. Check the gasket for the drain plug (located
inside the bowl) and the gasket for bowl (located
inside the filter head) for damage and wear
(
Figure 96 ).
Important:
Replace any damaged or worn
gaskets for the plug, bowl, or both.
8. Install the pressure filter element into the filter
head (
Figure 96 ).
Note:
Ensure that the filter element is firmly
seated into the filter head.
9. Install the bowl onto the filter head, and tighten
by hand (
Figure 96 ).
10. Assemble the drain cap onto the fitting at the
bottom of the bowl, and tighten the cap by hand
(
Figure 96 ).
64