REM (Remote Trigger)
FUSE REQUIREMENTS
While the panel on your TORO AUDIO amplifier incorporates one or more fuses, these do nothing
to protect the vehicle from a dangerous short circuit. It is absolutely vital that the main power lead to
the amplifier(s)in the system be fused within 18-inches(45cm) of the connection to the vehicle battery.
The value of this fuse (or circuit breaker) should be no greater than the sum of the fuses found on all
of the equipment being connected to that power wire.
This terminal must be connected to a sw12V source. Typically, remote turn-on leads are
provided at the source unit that will turn on and off the amplifier in correspondence with the source.
If the source unit does not have a remote turn-on lead, then a sw12V supply must be used,
like the ACC,+12V.
Run a minimum of 18-gauge wire from the amplifier location to the source of the sw12V lead.
If possible, route this wire on the same side of the vehicle as your power cable. Connect the source
remote output to the wire. Go back to the amplifier and cut the wire to length. Loosen the screw
terminal marked REM on the amplifier
