Note:
The end of the tie rod with the external
groove is a left-hand thread.
g004136
Figure 61
1.
Jam nut
3.
Wrench flat
2.
Tie rod
3.
To pivot the wheels, rotate the tie rod to by
turning it at the wrench flats (
).
4.
Measure the distance between the front of the
rear wheels and between the rear of the rear
wheels at axle height.
Note:
When the wheel alignment is correct,
you should measure 6 mm (1/4 inch) or less
between the front of the wheels and between
the rear of the wheels.
5.
Repeat steps
and
until the difference
between the front and rear is 6 mm (1/4 inch)
or less.
6.
Tighten the jam nut on each end of the tie rod
(
).
Cooling System
Maintenance
Cooling System Safety
•
Swallowing engine coolant can cause poisoning;
keep out of reach from children and pets.
•
Discharge of hot, pressurized coolant or touching
a hot radiator and surrounding parts can cause
severe burns.
– Always allow the engine to cool at least 15
minutes before removing the radiator cap.
– Use a rag when opening the radiator cap, and
open the cap slowly to allow steam to escape.
Removing Debris from the
Cooling System
Service Interval:
Before each use or daily (More
frequently in dirty operating
conditions).
1.
Park the machine on a level surface, lower the
cutting units, shut off the engine, engage the
parking brake, and remove the key.
2.
Remove the ball pin from the screen latch
(
)
g328488
Figure 62
1.
Ball pin
3.
Back of the machine
2.
Screen latch
3.
Unlatch the engine screen, open it, and lift it
from the machine (
).
49
