Toro LT2240, Руководство оператора

Страница: 54 / 68

Important:
Do not overfill the tank with
hydraulic fluid.
6. Install the cap onto the tank.
7. Install the storage compartment; refer to
Installing the Storage Compartment (page 36) .
Changing the Hydraulic
Return Filter
Service Interval: Every 1,000 hours— If you
are using the recommended
hydraulic fluid,
replace the
hydraulic return filter.
Every 500 hours— If you are not using the
recommended hydraulic fluid or have ever
filled the reservoir with an alternative fluid,
replace the hydraulic return filter.
1. Prepare the machine for maintenance; refer to
Preparing the Machine for Maintenance (page
35)
.
2. Unlatch and open the hood.
3. At the left side of the machine, clean the area
around the filter head and place a drain pan
under the filter (
Figure 85 ).
g348708
g348615
Figure 85
1. Filter head 2. Hydraulic fluid return filter
4. Remove the return filter ( Figure 85 ).
5. Lubricate the gasket of the new return filter with
clean hydraulic fluid.
6. Assemble the filter to the filter head, and tighten
the filter by hand until the gasket contacts the
mounting surface, then rotate it an additional 1/2
turn (
Figure 85 ).
7. Start the engine and let it run for 2 minutes to
purge air from the system.
8. Shut off the engine, remove the key, and check
for leaks.
9. Close and latch the hood.
Changing the Transmission
Fluid Filter
Service Interval: After the first 50 hours
Every 500 hours
1. Prepare the machine for maintenance; refer to
Preparing the Machine for Maintenance (page
35)
.
2. Unlatch and open the hood.
3. At the left side of the machine, clean the area
around the filter head and place a drain pan
under the filter housing (
Figure 86 ).
g348673
Figure 86
1. Filter head 3. Filter housing
2. Element
4. Remove the filter housing from the filter head
and remove the element (
Figure 86 ).
Note:
Discard the filter element.
5. Install a new filter element onto the filter head
(
Figure 86 ).
54