Toro LT2240, Руководство оператора

Страница: 45 / 68

temperature conditions, the battery electrolyte may
require adding water.
1. Prepare the machine for maintenance; refer to
Preparing the Machine for Maintenance (page
35)
.
2. Unlatch and open the hood.
3. At the left side of the machine, slip back the
battery terminal insulators (
Figure 70 ).
g348735
g348736
Figure 70
4. Remove any corrosion from the battery terminals
using a wire brush and to prevent further
corrosion.
Note:
Check the condition of the battery cables.
Install new cables when current ones are
showing signs of wear or damage, and tighten
any loose connections.
5. Apply Grafo 112X skin-over grease (Toro Part
No. 505-47) or petroleum jelly to the terminals.
6. Clean the battery compartment.
7. Close and latch the hood.
Checking the Electrical
System
Service Interval: Every 500 hours
Inspect all electrical connections and cables and
replace any which are damaged or corroded. Spray a
good-quality water inhibitor onto exposed connections
to prevent moisture ingress.
Checking the Fuses
1. Prepare the machine for maintenance; refer to
Preparing the Machine for Maintenance (page
35)
.
2. Unlatch and open the hood.
3. At the back of the bulkhead, remove the
fuse-block cover (
Figure 71 )
g348552
g348551
Figure 71
1. Fuse holder (maxi fuse) 3. Fuse-block cover
2. Maxi fuse-holder cover 4. Fuse block (ACT/ATO
blade)
4. Check for open fuses.
5. Replace any open fuse with a fuse of equal
amperage capacity (
Figure 72 ).
45