Toro HoverPro 450, Руководство оператора, Страница: 9 / 24

Refer to your engine owner’s manual for additional
information.
g017340
Figure 11
Checking the Engine-Oil
Level
1. Move the machine to a level surface.
2. Remove the dipstick by rotating the cap
counterclockwise and pulling it out (
Figure 12 ).
g017332
Figure 12
1. Full 3. Low
2. High
3. Wipe the dipstick clean with a clean cloth.
4. Insert the dipstick into the oil-fill tube, but do not
screw it in, then remove the dipstick.
5. Read the oil level on the dipstick ( Figure 12 ).
•
If the oil level on the dipstick is too low
(
Figure 12 ), carefully pour a small amount of
multigrade mineral SAE 10W-30 oil with an
API series classification of SJ or higher into
the oil-fill tube, wait 3 minutes, and repeat
steps
3 through 5 until the oil on the dipstick
is at the correct level.
•
If the oil level on the dipstick is too high
(
Figure 12 ), drain the excess oil until the oil
on the dipstick is at the correct level; refer to
Changing the Engine Oil (page 17) .
Important:
If the oil level in the engine is too
low or too high and you run the engine, you
may damage the engine.
6. Install the dipstick into the oil-fill tube securely.
Important:
Change the engine oil after the
first 5 operating hours ; change it yearly
thereafter. Refer to Changing the Engine Oil
(page 17) .
9