Toro Groundsmaster 360 31200 Series, Руководство оператора

Страница: 56 / 60

g014393
Figure 68
1. Transmission case drain
plug 3. Hydraulic reservoir drain
plug
2. Filter
4. Clean the area around the hydraulic oil filter and
remove it (
Figure 68 ).
5. Immediately install a new hydraulic oil filter.
6. Install the hydraulic reservoir and transmission
case drain plugs.
7. Fill the reservoir to the proper level
(approximately 17 liters [18 quarts]); refer to
Checking the Hydraulic Fluid.
8. Start the engine and check for oil leaks. Allow
the engine to run for about five minutes, then
shut it off.
9. After two minutes, check the level of the
hydraulic fluid; refer to Checking the Hydraulic
Fluid.
Cleaning
Waste Disposal
Engine oil, batteries, hydraulic oil, and engine coolant
are pollutants to the environment. Dispose of these
according to your state and local regulations.
56