Toro Groundsmaster 3320 Series, Руководство по установке, Страница: 5 / 20

1
Mounting the Control Valve
Parts needed for this procedure:
1 Control-valve assembly
1
Control-valve handle
1 Control-valve-pivot lever
1 Socket-head screw (#10 x 1-1/4 inch)
1 Locknut (#10)
1 Clevis pin
1 Cotter pin
3 Hydraulic hose
3 Bolt (1/4 x 2-3/4 inches)
3
Flange locknut (/4 inch)
Procedure
1. Remove the seat and the seat base from the machine.
2. Loosen the fuel tank mounting fasteners so that you
can raise the fuel tank enough to gain access to the
right fender.
3. Locate the 3 holes in the right fender.
•
If the rear hole is located 9.5 cm (3-3/4 inches)
from the edge of the fender as shown in
Figure 1 ,
proceed to step 4.
Figure 1
1. Right fender 2. 9.5 cm (3-3/4 inches)
•
If the rear hole is located 7.0 cm (2-3/4 inches)
from the edge of the fender as shown in
Figure 2 ,
relocate the holes. Use the dimensions in Figure 3
to locate, mark and drill 3 holes (8.7 mm or 11/32
inch) in the fender.
Figure 2
1. Right fender 2. 7.0 cm (2-3/4 inches)
Figure 3
1. 8.9 cm (3-1/2 inches) 4. 9.5 cm (3-3/4 inches)
2. 3.2 cm (1-1/4 inches) 5. 8.7 mm (11/32 inch)
diameter
3. 5.7 cm (2-1/4 inches)
Steps 4 through 8 pertain only to traction units
with serial numbers prior to 310999999.
4. Mount the control valve and the pivot lever to the right
fender with 3 bolts (1/4 x 2–3/4 inch) and 1/4 flange
locknuts as shown in
Figure 4 .
5