Toro GreensPro 1260, Руководство оператора

Страница: 9 / 36

•
In the front holes, use a bolt (M10 x 100
mm), 2 washers (M10), and a locknut (M10).
•
In the rear holes, use a bolt (M12 x 100 mm),
2 washers (M12), and a locknut (M12).
•
If your machine has a third washer included
with each bolt, use those washers as spacers
between the hitch and the inside of the hitch
pivot bracket (
Figure 6 ).
Note:
Use the holes in the hitch pivot bracket to
match the hitch height of the tow-vehicle hitch.
g025914
Figure 5
1. Hitch 5. Washer—M12 (2)
2. Hitch pivot bracket 6. Bolt (M12)
3. Washer—M10 (2) 7. Locknut (M12)
4. Bolt (M10) 8. Locknut (M10)
g025915
Figure 6
1. Spacer washers
3. Tighten the small bolt to 73 N∙m (54 ft-lb) and
the large bolt to 126 N∙m (93 ft-lb).
4. Push up on the hitch assembly until the latch
lever is unlocked from the slide detent (
Figure 7 ).
g024011
Figure 7
1. Latch lever
5. Pull the hitch down.
6. Step on the hitch pedal until the hitch locks into
place (
Figure 8 ).
9